User Tools

Site Tools


av:csy-2100

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
av:csy-2100 [2010/02/13 13:10] rgb32eav:csy-2100 [2015/04/07 05:43] – [SCART/RGB Pinout] segasonicfan
Line 9: Line 9:
 ===== SCART/RGB Pinout ===== ===== SCART/RGB Pinout =====
 The SCART RGB connector on the CSY-2100 is wired to the Standard SCART specification.  However, only RGBS and ground pins are used (audio and mode setting pins are not connected).  Like stated above both composite video or composite sync can be used on pin 20. The SCART RGB connector on the CSY-2100 is wired to the Standard SCART specification.  However, only RGBS and ground pins are used (audio and mode setting pins are not connected).  Like stated above both composite video or composite sync can be used on pin 20.
 +Note: Composite video must be used as the sync input, not TTL level C Sync that most consoles output.  To obtain proper 1Vp-p C Sync levels you can use one of these circuits: 
 +  *[[http://www.seekic.com/circuit_diagram/Basic_Circuit/Analog_Circuit/SYN_COMBINER.html]] 
 +  *[[http://gamesx.com/wiki/lib/exe/fetch.php?media=av:vga_sync_combiner.gif]] 
 +or just use the composite signal your console outputs.  For the circuits above, input your C Sync after the logic (which combines H+V) 
 +The sync (pin 20) is 75ohms terminated to ground at the input.
 ===== Variable Resistors (Internal Adjustments) ===== ===== Variable Resistors (Internal Adjustments) =====
 There are 6 variable resistors inside the CSY-2100.  This section will be updated upon determination of VR function and factory value. There are 6 variable resistors inside the CSY-2100.  This section will be updated upon determination of VR function and factory value.
av/csy-2100.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1