Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
av:g7000_av [2010/06/30 07:50]
LykaGreen
av:g7000_av [2013/03/07 11:04] (current)
Line 9: Line 9:
  
 ===== Modification ===== ===== Modification =====
-The composite video signal can be picked off pin 5 of if IC679 but it is unsuitable for driving a standard 75 ohm TV/monitor as is. The signal is only about half a volt in size so requires some amplification ​like a [[http://​www.njoyz.com/​vibrators.html|vibrator]]. The audio signal can be taken straight from pin 27 of IC652 but it is quite large and could do with some attenuation (unless you like it loud!). Here is a circuit for a suitable video amplifier. \\ {{av:​g7000av.png}} \\+The composite video signal can be picked off pin 5 of if IC679 but it is unsuitable for driving a standard 75 ohm TV/monitor as is. The signal is only about half a volt in size so requires some amplification. The audio signal can be taken straight from pin 27 of IC652 but it is quite large and could do with some attenuation (unless you like it loud!). Here is a circuit for a suitable video amplifier. \\ {{av:​g7000av.png}} \\
 Operation: Video is coupled via C1 and clamped (sync tip clamp) to a refrence voltage provided by R1 and R2. Voltage amplification is done by Q1/Q2 and associated resistors. Q3 is required to drive a low impedance monitor. Operation: Video is coupled via C1 and clamped (sync tip clamp) to a refrence voltage provided by R1 and R2. Voltage amplification is done by Q1/Q2 and associated resistors. Q3 is required to drive a low impedance monitor.
  
 
 av/g7000_av.txt ยท Last modified: 2013/03/07 11:04 (external edit)
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki