av:gamecube_rgb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| av:gamecube_rgb [2010/04/24 02:20] – gregorydom | av:gamecube_rgb [2019/08/27 20:45] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 73: | Line 73: | ||
| This also means that the three RCA jack cable is no longer useful since it won't be able to provide adequate sync to the monitor. So now the cable needs to be replaced. | This also means that the three RCA jack cable is no longer useful since it won't be able to provide adequate sync to the monitor. So now the cable needs to be replaced. | ||
| - | To start I cut off the male end of the HD-15 cable I showed earlier. I then cut off about an inch and a half of the insulation so I can get at the individual wires within. I strip off a little from each end of the wires and do some continuity testing to find the three video lines, the three ground wires for each video line, and the two sync lines. Of course, you can say " | + | To start I cut off the male end of the HD-15 cable I showed earlier. I then cut off about an inch and a half of the insulation so I can get at the individual wires within. I strip off a little from each end of the wires and do some continuity testing to find the three video lines, the three ground wires for each video line, and the two sync lines. |
| - | | write my essay]]" | + | |
| After finding all of the necessary wires I cut off the wires I won't be using, strip the insulation off of all three ground wires, braid the three ground wires with the main ground shield wire, and twirl it around near where the insulation was cut. | After finding all of the necessary wires I cut off the wires I won't be using, strip the insulation off of all three ground wires, braid the three ground wires with the main ground shield wire, and twirl it around near where the insulation was cut. | ||
av/gamecube_rgb.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1