Differences

This shows you the differences between two versions of the page.

--- av:japanese_rgb-21 [2005/12/25 10:51] – Added many new details nfg
+++ av:japanese_rgb-21 [2006/04/13 15:44] – Fixed an error in the 1st pinout diagram (audio pins were reversed) 64.75.150.222
@@ Line 1: / Line 1: @@
-===== Japanese 21-pin RGB connector =====
-The Japanese RGB-21 connector, also known as EIAJ TTC-003 apparently, is identical in appearance to the European [[scart_connector|SCART]] (or Péritel or Euroconnector).  The pinout is completely different however.  There's an RGB<- ->SCART adaptor pinout [[scart2rgb|here]].
-=== Simple version ===
-{{connectors:con-rgb21.gif}}
-^ Pin ^ Description ^ Pin ^ Description ^
-|  1 |Right audio  |  2 | NC  |
-|  3 |Left audio shield  |  4 |NC  |
-|  5 |Left audio  |  6 |NC  |
-|  7 |Sync shield  |  8 |NC  |
-|  9 |Sync  |  10 |NC  |
-|  11 |+5v  |  12 |NC  |
-|  13 |Red shield  |  14 |NC  |
-|  15 |Red  |  16 | 1V*  |
-|  17 |Green shield  |  18 |Blue shield  |
-|  19 |Green  |  20 |Blue  |
-|  21 | Ground  |
-  * *connect to pin 11 via 3.3k Ohm resistor.  The resistor isn't usually necessary, and +5v on this pin will most often work.
-=== Full Version ===
-This version includes every pin, including a few you'll never really need to know.  All labels are display-relative, so input means into the display.
-Most of these pins can be safely ignored for most purposes.
-{{connectors:con-rgb21.gif}}
-|  1  | Audio left channel input|  2  | Audio left channel output  |
-|  3  | Audio ground  |  4  | Audio ground  |
-|  5  | Audio right channel input  |  6  | Audio right channel output  |
-|  7  | Video ground  |  8  | Video ground  |
-|  9  | CVBS input  |  10  | CVBS output  |
-|  11  | AV control input  |  12  | Ym input  |
-|  13  | Red signal ground  |  14  | Ground  |
-|  15  | Red signal I/O  |  16  | Ys input|
-|  17  | Green signal ground  |  18  | Blue signal ground  |
-|  19  | Green signal I/O  |  20  | Blue signal I/O  |
-|  21  | Plug shield  |
-Special Notes:
-  * Audio Input: 0.40 mVrms, > 47K ohms
-  * Audio Output: 0.40 mVrms, > 10K ohms
-  * CVBS (Composite Video) in and out: 1 Vp-p, 75 ohms, sync: negative
-  * Ym Input: Switches RGB to half-brightness, for video overlay (L: < 0.4V, H: > 1V, 75 ohms)
-  * Ys Input: RGB in/out: (Ground for output, 1V+ for Input (preferred)((A lot of displays won't show RGB at all without Vcc on this line)))
-  * All RGB lines: 0.7 Vp-p, 75 ohms
-----
-The detailed version was found on [[http://vhd.co.kr/tech/if/d/d.htm|this Korean page]]