av:nintendomultiav
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
av:nintendomultiav [2009/02/15 14:32] – Link83 | av:nintendomultiav [2019/08/27 20:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 14: | Line 14: | ||
- | Note that Pin 3 can be either C-Sync or +12V depeding | + | Note that Pin 3 can be either C-Sync or +12V depending |
[Picture taken from an N64 motherboard on which most signals are already labelled] | [Picture taken from an N64 motherboard on which most signals are already labelled] | ||
Line 44: | Line 44: | ||
^ N64 | S-Video | 75ohm resistor to ground and 220uF capacitor* in series on Luma. 75ohm resistor to ground and 68nF capacitor in series on Chroma| Straight through to display | | ^ N64 | S-Video | 75ohm resistor to ground and 220uF capacitor* in series on Luma. 75ohm resistor to ground and 68nF capacitor in series on Chroma| Straight through to display | | ||
^ N64 | RGB | Requires modification first - Only a certain early French model - ' | ^ N64 | RGB | Requires modification first - Only a certain early French model - ' | ||
- | ^ Gamecube | Composite Video | 75ohm resistor to ground, 220uF capacitor* in series on Composite Video | Straight through to display | | + | ^ Gamecube | Composite Video | 75ohm resistor to ground |
^ Gamecube | S-Video | Does not output S-Video from the MultiAV port | Straight through to display | | ^ Gamecube | S-Video | Does not output S-Video from the MultiAV port | Straight through to display | | ||
^ Gamecube | RGB | 220uF Capacitors* in series on R, G & B. If you are going to watch/use the Composite video picture aswell (Scart connection) then you also need to use a 75ohm resistor to ground and 220uF capacitor* in series on Composite Video| Does not output RGB from the MultiAV port. RGB can be obtained from the ' | ^ Gamecube | RGB | 220uF Capacitors* in series on R, G & B. If you are going to watch/use the Composite video picture aswell (Scart connection) then you also need to use a 75ohm resistor to ground and 220uF capacitor* in series on Composite Video| Does not output RGB from the MultiAV port. RGB can be obtained from the ' | ||
Line 54: | Line 54: | ||
According to [[mailto: | According to [[mailto: | ||
- | Actually, there appears to be different PAL models with different RGB output. In my case, I had an RGB SCART cable designed for GameCube (I popped the SCART connector open, and there were resistors on the RGB pins). I also had two machines: " | + | Actually, there appears to be different PAL models with different RGB output. In my case, I had an RGB SCART cable designed for GameCube (I popped the SCART connector open, and there were resistors on the RGB pins)(But I'm going to [[http:// |
For reference, [[http:// | For reference, [[http:// |
av/nintendomultiav.1234672364.txt.gz · Last modified: 2019/08/27 20:44 (external edit)