Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
av:playstationav [2011/02/04 03:52]
rgb32e
av:playstationav [2014/01/15 14:17] (current)
ApolloBoy
Line 1: Line 1:
-===== Playstation ​1 + 2 AV Pinout ===== +===== PlayStation ​1 + 2 + 3 AV Pinout ===== 
-The Playstation ​AV Multi Out connector has everything you'll ever need for connecting it to the machine of your choice, except RF and Component.  ​+The PlayStation ​AV Multi Out connector has everything you'll ever need for connecting it to the machine of your choice, except RF and Component.  ​
  
-The Playstation ​uses the same connector, except that the RGB lines double as component-video. ​ Switching between the two is handled in the system menu.+The PlayStation ​and 3 use the same connector, except that the RGB lines double as component video. ​ Switching between the two is handled in the system menu on both systems.
  
 {{http://​www.gamesx.com/​grafx/​psxavcable.gif}}{{av:​psx_multi_av.jpg}} {{http://​www.gamesx.com/​grafx/​psxavcable.gif}}{{av:​psx_multi_av.jpg}}
Line 15: Line 15:
 |  7  |S-Video C  | |  7  |S-Video C  |
 |  8  |Video Ground ​ | |  8  |Video Ground ​ |
-|  9  |Blue  |+|  9  |Blue/Pb  |
 |  10  |+5 Volt  | |  10  |+5 Volt  |
-|  11  |Red  | +|  11  |Red/Pr  | 
-|  12  |Green ​ |+|  12  |Green/Y |
  
-Note: You must add a 220uf capacitor in each of the RGB lines (+ towards console) to get an acceptable picture. If you don't, the picture will be too dark and you won't like it!!+Note: You must add a 220 uF capacitor in each of the RGB lines (+ towards console) to get an acceptable picture. If you don't, the picture will be too dark and you won't like it!!
  
-Note: You will need to use an [[LM1881]] or similar circuit to strip the sync from the video line.  +Note: You will need to use an [[LM1881]] or similar circuit to strip the sync from the video line, as using RGB with composite video as sync will cause crosshatching on certain colors. You can also use the luma signal as sync to avoid this problem.
  
-The Playstation ​2 can do VGA through this port, however it is software controlled, and since there aren't enough pins for H+V Sync, it uses Sync-On-Green,​ which not all monitors support.+The PlayStation ​2 can do VGA through this port, however it is software controlled, and since there aren't enough pins for H+V Sync, it uses Sync-On-Green,​ which not all monitors support.
  
 ---- ----
Line 31: Line 31:
 FIXME: This page could use new pictures. FIXME: This page could use new pictures.
  
-Cabling configuration of official Sony Playstation ​RGB cables. ​ The official cables have 6 mini coaxes (R/​G/​B/​Cv/​L/​R),​ a single conductor for +5VDC, and a drain wire for the braided shield.+Cabling configuration of official Sony PlayStation ​RGB cables. ​ The official cables have 6 mini coaxes (R/​G/​B/​Cv/​L/​R),​ a single conductor for +5VDC, and a drain wire for the braided shield.
  
 {{:​av:​ps1_rgb_unterm.jpg|}} {{:​av:​ps1_rgb_unterm.jpg|}}
 
 av/playstationav.txt · Last modified: 2014/01/15 14:17 by ApolloBoy
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki