User Tools

Site Tools


av:scart2rgb

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
av:scart2rgb [2005/12/17 23:17] – Added image, clarified caveats, added diff. stars nfgav:scart2rgb [2006/10/30 21:47] – Added power link 210.49.242.31
Line 24: Line 24:
   * I used +5v for blanking, but you may need to use a 100Ohm resistor on this line.   * I used +5v for blanking, but you may need to use a 100Ohm resistor on this line.
   * Ground is Ground, you don't have to use separate wires from end to end.  One ground line is enough, but you must connect ALL the ground pins to each other on each end.   * Ground is Ground, you don't have to use separate wires from end to end.  One ground line is enough, but you must connect ALL the ground pins to each other on each end.
 +  * If you're connecting your display to a console or device that doesn't offer a blanking (power) signal, you can easily [[adding_5v_to_scart_lead|Add power to your SCART/RGB cable]]
  
av/scart2rgb.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1