Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
av:scart2rgb [2006/10/30 22:47]
210.49.242.31 Added power link
av:scart2rgb [2006/10/30 23:01]
210.49.242.31 Added power link
Line 24: Line 24:
   * I used +5v for blanking, but you may need to use a 100Ohm resistor on this line.   * I used +5v for blanking, but you may need to use a 100Ohm resistor on this line.
   * Ground is Ground, you don't have to use separate wires from end to end.  One ground line is enough, but you must connect ALL the ground pins to each other on each end.   * Ground is Ground, you don't have to use separate wires from end to end.  One ground line is enough, but you must connect ALL the ground pins to each other on each end.
 +
 +==== Other Useful Stuff ====
 +  * [[japanese_rgb-21|RGB-21 Connector]] in more detail
 +  * [[http://​www.gamesx.com/​hwb/​co_Scart.html | SCART connector]]
   * If you're connecting your display to a console or device that doesn'​t offer a blanking (power) signal, you can easily [[adding_5v_to_scart_lead|Add power to your SCART/RGB cable]]   * If you're connecting your display to a console or device that doesn'​t offer a blanking (power) signal, you can easily [[adding_5v_to_scart_lead|Add power to your SCART/RGB cable]]
  
 
 av/scart2rgb.txt ยท Last modified: 2018/03/16 21:22 by Lawrence
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki