This is an old revision of the document!

Sega Mark III RGB Amp

The Sega Mark III console has RGB output, but it's very weak. This amplifier will cure the problem.

It may also work with later revisions of the SG-1000 II which use an RGB-capable VDP, but this has not been tested.

The Circuit

  • This circuit will need to be repeated for every signal - Red, Green, Blue and Sync.
  • The variable resistor at the end is optional.

Alternate Circuit

You can also substitute the above amp with one based around the THS7314 chip. The amp design is based on the one found here, which was originally designed for the N64. The RGB inputs for the THS7314 are tapped directly from the VDP (these outputs are also marked on the motherboard), while 5V and ground can be pulled from the 7805 regulator. The resulting image will be very bright, so you may want to replace the 75 ohm resistors with ones of a higher value. For sync, you can use composite video, or you can substitute the THS7314 with a THS7374 to amplify the composite sync output in addition to the RGB signals.

As with the amplifier design above, this circuit may also work with the later version of the SG-1000 II.

Many thanks to Backup Technique (バックアップ括用テクニック) magazine (Volumes 8 + 9), from where the diagram for the first circuit came.

Thanks also to Kevin Horton, for helping fix the diagram, which was incorrect.

 av/sega_mark_iii_rgb_amp.1391211184.txt.gz · Last modified: 2014/02/01 10:33 by ApolloBoy
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki