caps:turbobooster
Turbo Booster
I love the Turbo Booster, it's so bad. It's about 80% bigger than the board it contains, but when attached to the TurboGrafx system it makes the whole thing look proportional.
Anyway it's got a few caps. They're all electrolytic 85° through-hole, and here's a list of 'em:
| µF | V | Qty | Label |
|---|---|---|---|
| 470 | 16 | 1 | C108 |
| 10 | 16 | 2 | C106, 1077 |
| 47 | 16 | 2 | C104, 105 |
| 1 | 50 | 3 | C101, 102, 103 |
ProTip: There are a couple of clips inside the Turbo Booster. To open the unit remove four screws, then press both of the clips in a little bit, and separate the two halves from the open side. Lift, and pull one half forward to separate.
caps/turbobooster.txt · Last modified: by NFG