| Pin | Description | - | Pin | Description |
|---|---|---|---|---|
| 1 | Common (GND) | - | 9 | D Button |
| 2 | NC | - | 10 | NC |
| 3 | Select | - | 11 | Start |
| 4 | D Button | - | 12 | C Button |
| 5 | B Button | - | 13 | A Button |
| 6 | Right | - | 14 | Left |
| 7 | Down | - | 15 | Up |
| 8 | +5v | - | - | - |
This diagram shows the connector looking at the console. These connectors should be available at any electronics store, or perhaps a computer store. It's the same as an IBM joystick connector.
- Pin 8 provides +5v to the controller. This is unused in the original stick, but is mandatory for proper use of the pads and new-style sticks.
- There are two D pins. While the controller returns low for both pins 9 and 4, only 4 is 'listened' to by the machine.
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
