Differences

This shows you the differences between two versions of the page.

Link to this comparison view

controls:snes2jamma [2006/10/07 09:16]
87.218.131.75 created
controls:snes2jamma [2019/08/27 20:45] (current)
Line 1: Line 1:
 +{{http://​nfg.2y.net/​games/​snesAC/​jg.png}}
  
 +{{http://​nfg.2y.net/​games/​snesAC/​snesAC.jpg}}
 +
 +This is a standard US model Super Nintendo with the guts ripped out and replaced with JAMMA PCB playing gear.
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes_AC2.jpg}}
 +
 +The fan sucks the hot air created by the power supply and replaces it with cool goodness. Remember kids: Melting = bad!
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes_AC4.jpg}}
 +
 +Replaced the original ports with DB15 plugs wired to NEO GEO spec.
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes_AC3.jpg}}
 +
 +When in use the expansion cover is removed and cool air enters through the hole.
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes3.jpg}}
 +
 +Since the JAMMA connector doesn'​t stick out very far, innovative solutions were required.
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes_AC6.jpg}}
 +
 +This is an innovative solution! One JAMMA harness connected to one JAMMA fingerboard,​ and presto - a JAMMA extension cable. Throw some shrink-tubing on there, dip the ends in plastic-dip,​ and it's a 4-foot piece of lovely.
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes_AC.jpg}}
 +
 +The guts. Not pretty. I did this some six years ago. I'm a lot better at it now, I swear.
 +
 +{{http://​nfg.2y.net/​games/​snesAC/​snes_AC5.jpg}}
 +
 +I re-used the existing SNES AV connector by cutting the PCB, and throwing everything away that wasn't involved in holding the back panel down.
 +
 +--
 +
 +[[http://​nfg.2y.net/​games/​snesAC/​|Original page]]
 
 
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki