This is an old revision of the document!
Table of Contents
Background
All X68000 computers suffer from the same 2 main problems:
- Bad power supply (due to blown capacitors and other failures)
- Dead SRAM save battery
Assuming you did a full capacitor kit on the computer, replaced or fixed the power supply and installed a new save battery to store SRAM settings, a good working X68000 will typically show you the following screen:
But on an XVI HD and potentially other HD computers, you might get a black screen. This tutorial will show you how to fix this problem.
Verify you have a good computer
Boot up the computer while holding the CLR button. If you get a screen asking you to initialize the SRAM, press Y. You can also verify you have a good working computer by pressing the INTERRUPT button on the top. If Japanese text pops up, then the video subsystem and system ROM is working correctly.
Problem and solution
It seems the HD version of the X68000 computers requires a hard drive to boot. The SCSI hard drive chain beings at the bottom I/O board, it connects to the external I/O adapter and lastly ends at the internal drive. The end of a SCSI chain must always have terminating resistors. Internal hard drives, or external hard drives/CD-ROM drives will have these at the end of the chain.
If you don't have any SCSI devices connected, the system ROM hangs waiting for the SCSI device.
To solve this problem, simply connect a SCSI device to the external output (like the SCSI2SD solution) or an internal SCSI hard drive with a terminator. Or, you can add an external SCSI terminator to the SCSI port, or add the missing terminator resistors internally (the internal resistors might prevent you from using an external SCSI2SD solution)
You can also confirm you have this problem by looking at the external I/O adapter. As you can see in the picture, the terminating resistors are missing (empty black sockets under the ribbon cable)
