Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
x68000:cz-6bs1_-_genuine_sharp_scsi_board [2011/12/12 01:44]
eidis
x68000:cz-6bs1_-_genuine_sharp_scsi_board [2011/12/20 04:27] (current)
eidis
Line 52: Line 52:
 4-2 Jumper settings 4-2 Jumper settings
  
-Jumpers JP1, JP2 set the interrupt priority for 68000MPU ​to level 2 or 4 (Source I/0 is available in two levels) and the board interprets from the jumper settings which one to use. Factory default is set to level 2. If you own the software, interrupt handling is set as follows. ​+Jumpers JP1, JP2 set the interrupt priority for 68000 CPU to level 2 or 4 (Source I/0 is available in two levels) and the board interprets from the jumper settings which one to use. Factory default is set to level 2. If you own the software, interrupt handling is set as follows. ​
 Set the priority level of the interrupt request signal with jumper JP2, set the interrupt priority level of the allowed signal with jumper JP1. The priority level can be selected as Level 2 or Level 4. Set the priority level of the interrupt request signal with jumper JP2, set the interrupt priority level of the allowed signal with jumper JP1. The priority level can be selected as Level 2 or Level 4.
  
 
 x68000/cz-6bs1_-_genuine_sharp_scsi_board.txt ยท Last modified: 2011/12/20 04:27 by eidis
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki