x68000:h.a.r.p_for_mc68000_-_cpu_accelerator_board
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
x68000:h.a.r.p_for_mc68000_-_cpu_accelerator_board [2012/02/05 04:52] – eidis | x68000:h.a.r.p_for_mc68000_-_cpu_accelerator_board [2012/02/05 05:08] – eidis | ||
---|---|---|---|
Line 9: | Line 9: | ||
{{: | {{: | ||
- | There is a red dipswitch in the center of the photo labeled SW1 which must be set to 2 (OFF) for normal operation | + | There is a red dipswitch in the center of the photo labeled SW1. Both switches |
☆ ☆ ☆ Oh!X Information ☆ ☆ ☆ | ☆ ☆ ☆ Oh!X Information ☆ ☆ ☆ | ||
H.A.R.P will accelerate the CPU and double its internal clock from 10MHz to 20MHz. However the factory default system bus speed will remain at 10MHz because it is needed for arbitration. That is, it will work in 20MHz when CPU calculates and in 10MHz when accessing external bus. Therefore, the actual speed increase is only about 10%. | H.A.R.P will accelerate the CPU and double its internal clock from 10MHz to 20MHz. However the factory default system bus speed will remain at 10MHz because it is needed for arbitration. That is, it will work in 20MHz when CPU calculates and in 10MHz when accessing external bus. Therefore, the actual speed increase is only about 10%. |
x68000/h.a.r.p_for_mc68000_-_cpu_accelerator_board.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1