x68000:soft_power_switch_troubleshooting_and_repair
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| x68000:soft_power_switch_troubleshooting_and_repair [2012/11/21 00:18] – eidis | x68000:soft_power_switch_troubleshooting_and_repair [2012/11/21 00:31] – eidis | ||
|---|---|---|---|
| Line 20: | Line 20: | ||
| The problem might be due to a signal that is always stuck Low. | The problem might be due to a signal that is always stuck Low. | ||
| - | If you look at the Buffered IO part in the schematics, 3 of these signals are connected to the MFP GPIP port. They can be queried via software and are connected like this : | + | If you look at the Buffered IO part in the schematics, 3 of these signals are connected to the MFP GPIP port. |
| + | |||
| + | **They can be queried via software and are connected like this :** | ||
| |/ | |/ | ||
x68000/soft_power_switch_troubleshooting_and_repair.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1