xbox_pcdvd
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| xbox_pcdvd [2009/06/06 22:48] – viletim | xbox_pcdvd [2009/06/06 22:49] – viletim | ||
|---|---|---|---|
| Line 39: | Line 39: | ||
| In addition, if it is desired to have the eject button on the PC-DVD inform the Xbox that the CD has been ejected, then a connection must be made from the NEJECT wire to the back of the Eject button on the front panel. The correct trace is the top one through an opening in the metal shielding. From the back, you can see four PCB pads, and the top two are connected together with a PCB trace. This is the location to connect the NEJECT signal, through a 3.3K resistor for a wired OR connection. | In addition, if it is desired to have the eject button on the PC-DVD inform the Xbox that the CD has been ejected, then a connection must be made from the NEJECT wire to the back of the Eject button on the front panel. The correct trace is the top one through an opening in the metal shielding. From the back, you can see four PCB pads, and the top two are connected together with a PCB trace. This is the location to connect the NEJECT signal, through a 3.3K resistor for a wired OR connection. | ||
| - | A schematic of the connector pinout and a sample interface circuit for the SD-M1302 is provided in this document: | + | A schematic of the connector pinout and a sample interface circuit for the SD-M1302 is provided in this document: |
| ===== Compatible DVD Drives ===== | ===== Compatible DVD Drives ===== | ||
xbox_pcdvd.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1