User Tools

Site Tools


arcade:joystick_mechs

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
arcade:joystick_mechs [2023/12/31 10:06] – [Sanwa] NFGarcade:joystick_mechs [2024/01/02 14:39] – [Hori] NFG
Line 45: Line 45:
 Sanwa sticks use a raised central circle around the pivot, to allow for the pivot to rise vertically above the nominal surface of the stick.  It's critical to allow for this when mounting it, or the stick will not work properly. Sanwa sticks use a raised central circle around the pivot, to allow for the pivot to rise vertically above the nominal surface of the stick.  It's critical to allow for this when mounting it, or the stick will not work properly.
 ===== Hori ===== ===== Hori =====
-Hori's made many mechs throughout their history.  Only one was designed and sold for arcade use: the Hayabusa ( 隼 ).  It uses a standard Sanwa mount, but uses a much larger base which may not directly fit a mount made for Sanwa's smaller base.  For example, the SNK Super 29 Candy cab's Sanwa plates, or Sanwa's JLF-P-1S.+Hori's made many mechs throughout their history.  Only one was designed and sold for different uses: the Hayabusa ( 隼 ).  It uses a standard Sanwa mount, both the four central holes and the outer 65mm mounts.  It does use a much larger base that surrounds the microswitches, which may not directly fit a mount made for Sanwa's smaller base.  For example, the SNK Super 29 Candy cab's Sanwa plates, or Sanwa's JLF-P-1S.  
  
 {{:arcade:hayabusa-mech-schematic.png?400|}}{{:arcade:hori-hayabusa-mech.jpg?400 | Hori Hayabusa Joystick Mechanism}} {{:arcade:hayabusa-mech-schematic.png?400|}}{{:arcade:hori-hayabusa-mech.jpg?400 | Hori Hayabusa Joystick Mechanism}}
  
-The Hayabusa shown above includes the mounting plate.  It is 36mm from top of plate to bottom of shaft, 78.5mm shaft length.+The Hayabusa shown above includes the mounting plate.  It is 36mm from top of plate to bottom of shaft, 78.5mm shaft length.  Standard Sanwa holes are underneath. 
 + 
 +[[Hori Hayabusa|Hori Hayabusa Info Page]]
  
 ===== ASCII ===== ===== ASCII =====
arcade/joystick_mechs.txt · Last modified: 2024/06/21 00:10 by NFG