arcade:joystick_mechs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
arcade:joystick_mechs [2024/01/02 14:39] – [Hori] NFG | arcade:joystick_mechs [2024/05/01 22:25] – [Seimitsu 40mm Mechs] Added LS-33 NFG | ||
---|---|---|---|
Line 22: | Line 22: | ||
* LS-56 | * LS-56 | ||
* LS-55 | * LS-55 | ||
+ | * LS-33 | ||
==== Seimitsu 50mm Mechs ==== | ==== Seimitsu 50mm Mechs ==== | ||
Line 32: | Line 32: | ||
SNK's home consoles used Seimitsu mechs (or clones of them) with a 40mm pattern. | SNK's home consoles used Seimitsu mechs (or clones of them) with a 40mm pattern. | ||
- | These same mechs (or clones of them) were also used in sticks from Sigma and (IIRC) ASCII. | + | These same mechs (or clones of them) were also used in sticks from Sigma (The Σ-2200 definitely used a Seimitsu mech) and (IIRC) ASCII. |
{{: | {{: | ||
===== Sanwa ===== | ===== Sanwa ===== | ||
- | Sanwa' | + | Sanwa' |
- | The two 65mm holes are not threaded, and typically use a nut & bolt attachment. | + | {{ : |
- | Sanwa sticks are mounted deeper into the panel compared to Seimitsu sticks. | + | The two 65mm holes in both the JLX and JLF are not threaded, and typically use a nut & bolt attachment. |
+ | |||
+ | The JLF 4-hole mounts are plastic and use self-tapping counter-sink screws to fix the mech to the plate. The JLX sticks however use threaded metal inserts, and so must use different screws than the JLF mechs. | ||
+ | |||
+ | Sanwa sticks are mounted deeper into the panel compared to Seimitsu sticks. | ||
Sanwa sticks use a raised central circle around the pivot, to allow for the pivot to rise vertically above the nominal surface of the stick. | Sanwa sticks use a raised central circle around the pivot, to allow for the pivot to rise vertically above the nominal surface of the stick. | ||
Line 64: | Line 68: | ||
This mech is compatible with Sanwa JLF mounts and accessories. | This mech is compatible with Sanwa JLF mounts and accessories. | ||
+ | |||
+ | ===== Nintendo ===== | ||
+ | Back in the 80s, with Donkey Kong and Popeye, the Vs cabinets, and even R-Type (which Nintendo distributed in North America) Nintendo used an all-metal joystick that was small, clicky, had an incredibly short throw, and a very short shaft. | ||
+ | |||
arcade/joystick_mechs.txt · Last modified: 2024/06/21 00:10 by NFG