arcade:joystick_mechs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
arcade:joystick_mechs [2024/01/02 14:41] – [SNK / Sigma / ASCII / Seimitsu] NFG | arcade:joystick_mechs [2024/01/06 08:49] – [Sanwa] NFG | ||
---|---|---|---|
Line 39: | Line 39: | ||
Sanwa' | Sanwa' | ||
- | The two 65mm holes are not threaded, and typically use a nut & bolt attachment. | + | {{ : |
- | Sanwa sticks are mounted deeper into the panel compared to Seimitsu sticks. | + | The two 65mm holes in both the JLX and JLF are not threaded, and typically use a nut & bolt attachment. |
+ | |||
+ | The JLF 4-hole mounts are plastic and use self-tapping counter-sink screws to fix the mech to the plate. The JLX sticks however use threaded metal inserts, and so must use different screws than the JLF mechs. | ||
+ | |||
+ | Sanwa sticks are mounted deeper into the panel compared to Seimitsu sticks. | ||
Sanwa sticks use a raised central circle around the pivot, to allow for the pivot to rise vertically above the nominal surface of the stick. | Sanwa sticks use a raised central circle around the pivot, to allow for the pivot to rise vertically above the nominal surface of the stick. |
arcade/joystick_mechs.txt · Last modified: 2024/05/03 15:25 by NFG