av:nintendomultiav
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
av:nintendomultiav [2009/01/13 05:31] – 82.16.39.139 | av:nintendomultiav [2009/02/15 14:10] – Link83 | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== SNES/ | ===== SNES/ | ||
- | Cable | + | Cable: |
{{http:// | {{http:// | ||
Line 9: | Line 9: | ||
{{av: | {{av: | ||
+ | Motherboard Pinout: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | Note that Pin 3 can be either C-Sync or +12V depeding on the consoles region (NTSC or PAL). | ||
+ | [Picture taken from an N64 motherboard as most signals are already labelled] | ||
+ | |||
+ | |||
+ | Pinout Chart: | ||
^Pin^Name^Description^Pin^Name^Description^ | ^Pin^Name^Description^Pin^Name^Description^ | ||
- | | 1 | R | RGB Red | 2 | G | RGB Green | | + | | 1 | R | RGB Red | 2 | G | RGB Green | |
| 3 | CSYNC* | Composite Sync* | 4 | B | RGB Blue | | | 3 | CSYNC* | Composite Sync* | 4 | B | RGB Blue | | ||
| 5 | GND | Ground | | 5 | GND | Ground | ||
- | | 7 | Y | S-Video Y (luma) | + | | 7 | Y | S-Video Y (Luma) |
| 9 | CVBS | Composite Video | 10 | +5V | +5 Volts | | | 9 | CVBS | Composite Video | 10 | +5V | +5 Volts | | ||
| 11 | L | Left Audio | 12 | R | Right Audio | | | 11 | L | Left Audio | 12 | R | Right Audio | | ||
- | *C-Sync is replaced by +12V on PAL SNES and PAL Gamecube consoles (But not the PAL N64) | + | *CSYNC/ |
Not all signals are available on all systems: | Not all signals are available on all systems: | ||
Line 24: | Line 34: | ||
^ RGB | N | Y | N | N | N | Y | | ^ RGB | N | Y | N | N | N | Y | | ||
- | Some AV cables | + | Some AV cables |
+ | |||
+ | ^ Console ^ Signal ^ PAL ^ NTSC ^ | ||
+ | ^ SNES | Composite Video | 75ohm resistor to ground on Composite Video | Straight through to display | | ||
+ | ^ SNES | S-Video | Outputs S-Video but cable components (if any) are unknown at this time | Straight through to display | | ||
+ | ^ SNES | RGB | 75ohm resistors to ground on R, G, B and Composite Video | 220uF Capacitors* in series on R, G & B | | ||
+ | ^ N64 | Composite Video | 75ohm resistor to ground on Composite Video (and 220uF capacitor* in series is also recommended) | Straight through to display | | ||
+ | ^ N64 | S-Video | 75ohm resistor to ground and 220uF capacitor* in series on Luma. 75ohm resistor to ground and 68nF capacitor in series on Chroma| Straight through to display | | ||
+ | ^ N64 | RGB | Requires modification first - Only a certain early French model - ' | ||
+ | ^ Gamecube | Composite Video | 75ohm resistor to ground, 220uF capacitor* in series on Composite Video | Straight through to display | | ||
+ | ^ Gamecube | S-Video | Does not output S-Video from the MultiAV port | Straight through to display | | ||
+ | ^ Gamecube | RGB | 220uF Capacitors* in series on R, G & B. If you are going to watch/use the Composite video picture aswell (Scart connection) then you also need to use a 75 ohm resistor to ground and 220uF capacitor* in series on Composite Video| Does not output RGB from the MultiAV port. RGB can be obtained from the ' | ||
- | ^ Signal/ | + | *220uF capacitors are polarised, and it is important that the positive leg always goes towards |
- | ^ Composite Video (SNES, N64, Gamecube) | 75ohm resistor to ground, | + | |
- | ^ S-Video Y (N64) | 75ohm resistor to ground, 220uF capacitor in series | Straight through to display | | + | |
- | ^ S-Video C (N64) | 75ohm resistor to ground, 68nF capacitor in series | Straight through to display | | + | |
- | ^ RGB (SNES) | 33ohm (or 47ohm) resistor in series | + | |
- | ^ RGB (Gamecube) | 220uF capacitor in series (R, G and B) (+towards | + | |
- | *The PAL SNES was internally revised 4 or 5 times during its lifetime. Later consoles | + | The PAL SNES was internally revised 4 or 5 times during its lifetime. Later consoles |
According to [[mailto: | According to [[mailto: |
av/nintendomultiav.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1