controls:x686button
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
controls:x686button [2009/12/04 07:19] – TheRogue | controls:x686button [2011/01/07 14:50] – unixgamerocker | ||
---|---|---|---|
Line 27: | Line 27: | ||
{{: | {{: | ||
- | Step 3: Cut the black (#1), grey (#7), and white (#9) wires directly in the middle, so an equal length remains on both sides. | + | Step 3: Cut the black (#1), grey (#7), and white (#9) wires directly in the middle, so an equal length remains on both sides. |
Step 4: Re-connect the wires in the following way: | Step 4: Re-connect the wires in the following way: | ||
NOTE: The copper wire inside the genesis controllers is of very poor quality and breaks easily, so is it advisable to wrap each solder joint liberally with electrical tape immediately after making the join or the wire is apt to snap. | NOTE: The copper wire inside the genesis controllers is of very poor quality and breaks easily, so is it advisable to wrap each solder joint liberally with electrical tape immediately after making the join or the wire is apt to snap. | ||
- | Cable side - Controller side | + | ^ Cable side ^ Controller side ^ |
- | Black (#1) - Gray (#7) | + | | |
- | Gray (#7) - White (#9) | + | | |
- | White (#9) - Black (#1) | + | | |
Step 5: Make sure that all your solder joints are insulated, then close the controller up. | Step 5: Make sure that all your solder joints are insulated, then close the controller up. | ||
This pad will function with any game using the MD-to-X68000 adapter that came with Street Fighter or Atomic Runner Chelnov, as well as an FM Towns games using similar adapters. | This pad will function with any game using the MD-to-X68000 adapter that came with Street Fighter or Atomic Runner Chelnov, as well as an FM Towns games using similar adapters. |
controls/x686button.txt · Last modified: 2022/05/16 02:59 by BlueBMW