controls:x686button
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| controls:x686button [2009/12/04 07:22] – TheRogue | controls:x686button [2011/01/07 14:50] – unixgamerocker | ||
|---|---|---|---|
| Line 32: | Line 32: | ||
| NOTE: The copper wire inside the genesis controllers is of very poor quality and breaks easily, so is it advisable to wrap each solder joint liberally with electrical tape immediately after making the join or the wire is apt to snap. | NOTE: The copper wire inside the genesis controllers is of very poor quality and breaks easily, so is it advisable to wrap each solder joint liberally with electrical tape immediately after making the join or the wire is apt to snap. | ||
| - | Cable side - Controller side | + | ^ Cable side ^ Controller side ^ |
| - | Black (#1) - Gray (#7) | + | | |
| - | Gray (#7) - White (#9) | + | | |
| - | White (#9) - Black (#1) | + | | |
| Step 5: Make sure that all your solder joints are insulated, then close the controller up. | Step 5: Make sure that all your solder joints are insulated, then close the controller up. | ||
| This pad will function with any game using the MD-to-X68000 adapter that came with Street Fighter or Atomic Runner Chelnov, as well as an FM Towns games using similar adapters. | This pad will function with any game using the MD-to-X68000 adapter that came with Street Fighter or Atomic Runner Chelnov, as well as an FM Towns games using similar adapters. | ||
controls/x686button.txt · Last modified: 2022/05/16 02:59 by BlueBMW