ps2psxlcd:sony_psx_screen_on_ps2_info
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ps2psxlcd:sony_psx_screen_on_ps2_info [2010/01/26 10:15] – tertiumsquid | ps2psxlcd:sony_psx_screen_on_ps2_info [2010/01/26 10:27] – tertiumsquid | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | Will be updating/ | ||
- | |||
A common problem with creating portable PSTwo systems is that the screen turns green after 20 or 30 minutes. | A common problem with creating portable PSTwo systems is that the screen turns green after 20 or 30 minutes. | ||
Line 24: | Line 22: | ||
Now for pictures: | Now for pictures: | ||
- | |||
- | All pictures were taken with fixed white balance on my Canon EOS 300D. Raw format, no retouching afterward, except for a tad of brightness adjustment. Resized to 800x600, then saved as a jpg, compression level 8. On my monitor, the colors shown accurately represent what was shown on the Sony LCD. | ||
These are the 3 caps in question. Basically, I've removed them and resoldered them upright, so as to only connect on one end. I then soldered the 3 wires to the PCB input connector. Note that I've lifted the lower side of the cap up, so that it's standing only on the upper connection of the footprint. | These are the 3 caps in question. Basically, I've removed them and resoldered them upright, so as to only connect on one end. I then soldered the 3 wires to the PCB input connector. Note that I've lifted the lower side of the cap up, so that it's standing only on the upper connection of the footprint. | ||
+ | |||
+ | {{: | ||
Here's the other end of those wires. I used 30ga insulated magnet wire for this, but you can use whatever you want. On the input connector, pins 4, 5, and 6 (counted from bottom up) correspond to red, green, and blue. | Here's the other end of those wires. I used 30ga insulated magnet wire for this, but you can use whatever you want. On the input connector, pins 4, 5, and 6 (counted from bottom up) correspond to red, green, and blue. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | Here's Okami after about 90 minutes: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | Any question or comments, please post in my original thread [[http:// |
ps2psxlcd/sony_psx_screen_on_ps2_info.txt · Last modified: 2022/04/08 14:11 by tertiumsquid