Differences

This shows you the differences between two versions of the page.

--- x68000:040excel_necessary_modifications [2015/06/14 15:56] – hyperneogeo
+++ x68000:040excel_necessary_modifications [2015/06/19 11:22] – hyperneogeo
@@ Line 59: / Line 59: @@
 {{ :x68000:jumper.jpg?100 |}}
-Next there are 2 AS245s, connect the 19th pin to the reconfiguring cable, and 10th pin to ground. And then make 2 jumper sockets. And configure the jumpers as 2-18, 3-17.....9-11... etc.
+Next there are 2 AS245s, connect the 19th pins to the reconfiguring cable, and 10th pin to ground. And then make 2 jumper sockets. And configure the jumpers as 2-18, 3-17.....9-11... etc.
 　次にＡＳ245を二つの、１９ピンに改造用ケーブルの線をつなぐ。もち、１０ピンはＧＮＤ。
@@ Line 66: / Line 66: @@
 {{ :x68000:kaizou.jpg?100 |}}
-Put IC 4, 5 in the jumper socket, then IC11, 12...and that should do it for the AS245s. Finally take the reconfiguring cable and connect it to the EXCEL, then you are done.
+Put IC 4, 5 in the jumper socket, then the AS245s into IC11, 12 ...and that should do it for the AS245s. Finally take the reconfiguring cable and connect it to the EXCEL, then you are done.
 ＩＣ4，5にジャンパソケット、ＩＣ11，12に改造済みＡＳ245、改造用ケーブルをエクセルにつないで完成。