x68000:internet_on_x68000_using_ethernet_or_null_modem_cable
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
x68000:internet_on_x68000_using_ethernet_or_null_modem_cable [2019/01/26 08:15] – [Ethernet Instructions] wording. neko68k | x68000:internet_on_x68000_using_ethernet_or_null_modem_cable [2019/01/26 08:45] – [Ethernet Instructions] details about +router neko68k | ||
---|---|---|---|
Line 69: | Line 69: | ||
[[http:// | [[http:// | ||
- | I followed the steps [[https:// | + | I followed the steps [[https:// |
*On your x68k run PPPX.BAT. | *On your x68k run PPPX.BAT. | ||
Line 84: | Line 84: | ||
=== General === | === General === | ||
- | Add your ethernet driver to ' | + | Add your ethernet driver to ' |
I recommend creating a BAT file with the following commands: | I recommend creating a BAT file with the following commands: | ||
Line 93: | Line 93: | ||
inetdconf +dns 8.8.8.8 +domain x68k +router 192.168.0.1 | inetdconf +dns 8.8.8.8 +domain x68k +router 192.168.0.1 | ||
</ | </ | ||
+ | |||
+ | In the above snippet ' | ||
Run your BAT file and test with ' | Run your BAT file and test with ' | ||
Line 99: | Line 101: | ||
*Use OpenVPN TAP driver. | *Use OpenVPN TAP driver. | ||
| | ||
- | *You _must_ set a static IP to the TAP device before bridging. This IP should be in your local subnet (ex. 10.0.0.x, 162.168.0.x). The default router should be _your_ router (ex. 10.0.0.1, 192.168.0.1). | + | *You _must_ set a static IP to the TAP device before bridging. This IP should be in your local subnet (ex. 10.0.0.x, 162.168.0.x). The default router should be _your_ router (ex. 10.0.0.1, 192.168.0.1). |
| | ||
*In XM6G put your TAP interface name in the Nereid tab. | *In XM6G put your TAP interface name in the Nereid tab. |
x68000/internet_on_x68000_using_ethernet_or_null_modem_cable.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1