Differences

This shows you the differences between two versions of the page.

--- x68000:writing_floppies [2014/08/08 00:20] – eidis
+++ x68000:writing_floppies [2015/04/04 07:05] – [Windows] segasonicfan
@@ Line 15: / Line 15: @@
   * [[http://www.shlock.co.uk/Utils/OmniFlop/OmniFlop64.htm|OmniFlop 64bit version]] if you are using Windows Vista64, Windows7 x64 or newer 64bit OS
-OmniFlop requires a built-in **NEC-compatible** floppy disk controller. You can use the Diagnostic options of OmniFlop to see if this holds for your system.
+OmniFlop requires a built-in **NEC-compatible** floppy disk controller. You can use the Diagnostic options of OmniFlop to see if this holds for your system.  You should also check your motherboard BIOS to see if it supports 5.25" 1.2MB writing.
 **Omniflop Install&Format 5.25" floppies:**
@@ Line 32: / Line 32: @@
   - Select Drive Unit and make sure that Autodetect format is selected
   - In next window you can read: Select a format to write...ALL, below you should see Sharp X68000 78-Track (default format), click Next
-  - In file: you can select only .XDF files
+  - In file: you can select only .XDF files (You have to select "show all files" from bottom right window)
   - Click next and it will begin to Write .XDF disk image to 5.25" floppy disk
   - After write process has finished, it is normal to see the following warning message:
     * The file is smaller than the disk - not all of the disk has been writen.
     * Apart from this, the operation completed OK
+  - You can ignore this message and press close.
+  - Alternatively, you can select "Format-Write" from the Omniflop option screen.  This is a faster way to make images.
+**Using Virtual Floppy Image Converter:**
+[[http://www.vector.co.jp/soft/win95/util/se151106.html|Download]]
+   Many image files you will find online are not .XDF format but in fact .DIM files.  You will need to convert these
+   before writing floppys to use on your X68000.
+  - The install is straightforward, just select your language and your output folder.  You can drag your .DIM images
+  right into the window to convert them.  Note: If you need to change the language, read the "Readme" file in the
+  install folder for using command prompt to do this.  This is only necessary if you select the wrong language on first
+  start up because reinstalling the program does not change the language.
 ===== Mac =====