x68000:xsimm6_-_memory_expansion_board
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
x68000:xsimm6_-_memory_expansion_board [2011/12/12 01:08] – eidis | x68000:xsimm6_-_memory_expansion_board [2011/12/12 05:11] – eidis | ||
---|---|---|---|
Line 12: | Line 12: | ||
| XSIMM6 | | XSIMM6 | ||
- | These XSIMM boards use SIMM module | + | These XSIMM boards use the following 72pin SIMM memory modules which height must not exceed 30 mm (the default height is 25 mm). |
- | For compatible | + | |
+ | *Macintosh: 8-bit, 72-pin | ||
- | • PC / AT: 9 bit (with parity) 72 pin for Macintosh: 8-bit or 72-pin | + | It supports |
+ | There is a dip-switch panel in the middle of the board right below the SIMM socket. | ||
+ | The dip-switch settings are as follows: | ||
- | Middle of the board as the left picture, the bottom of the SIMM installed, with a dip switch to set the memory in this expansion area. | + | |{{: |
- | DIP switch settings, proceed as follows. | + | |
- | |{{: | + | The memory will be expanded with additional 6MB even if an 8MB SIMM will be installed and all four switches |
- | + | ||
- | Ie, or 8MB SIMM in place 6MB, if all four switches to ON, additional capacity is 6MB. (Set the picture above). | + | |
- | + | ||
- | * The product' | + | |
x68000/xsimm6_-_memory_expansion_board.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1