arcade:adaptor_plates
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
arcade:adaptor_plates [2023/11/28 23:09] – [Sega] NFG | arcade:adaptor_plates [2023/12/01 23:34] (current) – NFG | ||
---|---|---|---|
Line 4: | Line 4: | ||
You can have a look at the panels and sticks on these pages: | You can have a look at the panels and sticks on these pages: | ||
* [[arcade: | * [[arcade: | ||
- | * [[arcade:joysticks_control_panels|Joysticks | + | * [[arcade:control_panels|Joysticks |
==== SNK ==== | ==== SNK ==== | ||
Line 13: | Line 13: | ||
Several sizes of plates will fit here. The two important dimensions are 96mm for the mounting screws, and 10mm depth. | Several sizes of plates will fit here. The two important dimensions are 96mm for the mounting screws, and 10mm depth. | ||
- | ==== Sega ==== | + | ==== Sega City Mount v1 ==== |
Sega used this panel mount for their Aero and Astro City cabinets, as well as the [[controls: | Sega used this panel mount for their Aero and Astro City cabinets, as well as the [[controls: | ||
{{: | {{: | ||
- | {{ :arcade:sega_adaptor_plate.png?400 |Sega Joystick Adaptor Plate (Sanwa)}} | + | {{ :arcade:sanwa_jlf-p-1s_plate.png?400 |Sega Joystick Adaptor Plate (Sanwa)}} |
+ | |||
+ | The Sanwa JLF-P-1S plate is still sold by Sanwa. | ||
+ | ==== Sega City Mount v2 ==== | ||
+ | This mount was used on the Sega cabinets that followed the New Astro City. It's much smaller than the City mount, with two 65mm screws and a 6mm depth. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | The VF and SE Base plates both use countersunk screw, and will mount flush when installed. | ||
- | Note that some Seimitsu sticks use a 50mm pattern. |
arcade/adaptor_plates.1701176950.txt.gz · Last modified: 2023/11/28 23:09 by NFG