PCB | µF | V | Height | Width | qty |
---|---|---|---|---|---|
I/O Board | |||||
C202, C204, C207, C226, C201, C260 | 4.7 | 50 | 1.2 | 0.5 | 6 |
C208 | 47 | 16 | 1.2 | 0.5 | 1 |
C210 | 100 | 6.3 | 1.2 | 0.5 | 1 |
C209 | 100 | 16 | 1 | 0.6 | 1 |
C211, C242 | 100 | 16 | 0.8 | 1.1 | 2 |
C217 | 22 | 16 | 0.6 | 0.5 | 1 |
C218 | 1 | 50 | 0.6 | 0.3 | 1 |
C224, C249, C212 | 100 | 6.3 | 1 | 0.5 | 3 |
C225 | 10 | 16 | 1.2 | 0.5 | 1 |
C264, C247, C231, C232 | 0.47 | 50 | 1.2 | 0.5 | 4 |
C243 | 100 | 10 | 0.7 | 0.6 | 1 |
C230 | 4.7 | 50 | 0.7 | 0.5 | 1 |
C227 | 100 | 16 | 1.1 | 0.6 | 1 |
C228 | 100 | 16 | 0.7 | 0.6 | 1 |
C203 | 4.7 | 50 | 0.6 | 0.5 | 1 |
C236 | 0.47 | 50 | 0.6 | 0.4 | 1 |
C237, C238 | 100 | 6.3 | 1.2 | 0.4 | 2 |
C258, C233 | 1 | 50 | 1 | 0.5 | 2 |
C234, C261 | 100 | 10 | 1.1 | 0.5 | 2 |
C259 | 100 | 16 | 1.1 | 1.1 | 1 |
C253, C252 | 47 | 16 | 1.1 | 0.5 | 2 |
Right end of R256 and pin 15 of IC229 | 47 | 16 | 0.7 | 0.7 | 1 |
C235 | 100 | 16 | 0.7 | 0.7 | 1 |
PCB | µF | V | Height | Width | qty |
GFX Board | |||||
C403, C404, C405 | 470 | 10 | 1.2 | 0.8 | 3 |
C406, C411 | 100 | 6.3 | 1.1 | 0.5 | 2 |
C407, C408, C410 | 100 | 16 | 1.1 | 0.6 | 3 |
PCB | µF | V | Height | Width | qty |
Main Mobo Board | |||||
C24 | 220 | 6.3 | 1 | 0.8 | 1 |
C16 | 470 | 10 | 1.2 | 0.8 | 1 |
C17 | 2200 | 6.3 | 2 | 1.3 | 1 |
C10 | 0.47 | 50 | 0.7 | 0.4 | 1 |
PCB | µF | V | Height | Width | qty |
Riser Board | |||||
C801, C802 | 47 | 10 | 0.7 | 0.7 | 2 |
C803, C804 | 47 | 16 | 0.7 | 0.7 | 2 |
PCB | µF | V | Height | Width | qty |
1xFloppy Drive | |||||
C16, C17 | 47 | 16 | 0.7 | 0.7 | 2 |
C18, C19, C20, C21 | 10 | 16 | 0.7 | 0.5 | 4 |
MISC | µF | V | Height | Width | qty | |
---|---|---|---|---|---|---|
farthest from the main edge connector | 0.47 | 50 | 0.7 | 0.4 | 1 | all negatives on left side, closer to the corner motor |
middle | 22 | 16 | 0.7 | 0.5 | 1 | there is space for 4mm wide capacitor if you lay it flat |
closer to main edge connector | 0.1 | 50 | 0.7 | 0.4 | 1 | and mount on back side of board since it's very hard to get them back the normal way |
Source: Forum post by skpstmgs