Differences

This shows you the differences between two versions of the page.

--- arcade:adaptor_plates [2023/11/26 11:39] – created NFG
+++ arcade:adaptor_plates [2023/12/01 23:34] (current) – NFG
@@ Line 4: / Line 4: @@
 You can have a look at the panels and sticks on these pages:
   * [[arcade:joystick_mechs|Joystick Mechanisms]]
-  * [[arcade:joysticks_control_panels|Joysticks &amp; Control Panels]]
+  * [[arcade:control_panels|Joysticks in Control Panels]]
 ==== SNK ====
 Used on the Super Neo 29 Candy, and probably others, this mount is the same as the ones used on Sega's Astro City panels (which were also used on many Sega cabs) except the depth is 10mm, where Sega's is 14mm.  It uses only two screws, at 95mm, to affix the plate.
-{{ :arcade:snk_adaptor_plate.png?400 |SNK Super Neo 29 Candy Adaptor Plate}}
+{{ :arcade:snk_adaptor_plate.png?400 |SNK Joystick Adaptor Plate (Sanwa)}}
+Several sizes of plates will fit here.  The two important dimensions are 96mm for the mounting screws, and 10mm depth.  You should also make sure the central hole fits your stick, but anything over 21mm should do.
+==== Sega City Mount v1 ====
+Sega used this panel mount for their Aero and Astro City cabinets, as well as the [[controls:virtuastickpro|Sega Virtua Stick Pro]].  Two 96mm spaced screws and a 14mm rise.
+{{:arcade:sega_adaptor_plate-sr.png?400|Seimitsu Regular Adaptor Plate}} {{:arcade:sega_adaptor_plate-ss.png?400|Seimitsu Small Adaptor Plate}}
+{{ :arcade:sanwa_jlf-p-1s_plate.png?400 |Sega Joystick Adaptor Plate (Sanwa)}}
+The Sanwa JLF-P-1S plate is still sold by Sanwa.
+==== Sega City Mount v2 ====
+This mount was used on the Sega cabinets that followed the New Astro City.  It's much smaller than the City mount, with two 65mm screws and a 6mm depth.  Seimitsu makes 3 adaptor plates to fit this mount.
+{{:arcade:seimitsu-vfbase.png?400|Seimitsu VF Base Adaptor Plate}} {{:arcade:seimitsu-sebases.png?400|Seimitsu SE Base Adaptor Plate}}
+The VF and SE Base plates both use countersunk screw, and will mount flush when installed.  The All in One plate below does not use countersunk screws and will sit .8mm (the height of the screw head) away from the panel mount.
-Several sizes of plates will fit here.  The plate shown is for a Sanwa mech, plates for Seimitsu sticks are larger than Sanwa plates (64mm wide).  The two important dimensions are 96mm for the mounting screws, and 10mm depth.  You should also make sure the central hole fits your stick, but anything over 21mm should do.