NFG Games + GameSX

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Hori =====
Hori's made many mechs throughout their history.  Only one was designed and sold for different uses: the Hayabusa ( 隼 ).  It uses a standard Sanwa mount, both the four central holes and the outer 65mm mounts.  It does use a much larger base that surrounds the microswitches, which may not directly fit a mount made for Sanwa's smaller base.  For example, the SNK Super 29 Candy cab's Sanwa plates, or Sanwa's JLF-P-1S.  

{{ :arcade:hori-hayabusa-mech.jpg?400 |Hori Hayabusa joystick mech}}

The Hayabusa shown above includes the mounting plate.  It is 36mm from top of plate to bottom of shaft, 78.5mm shaft length.  

{{ :arcade:hori_hayabusa_joystick_mech-3.jpg?400 |Hori Hayabusa joystick without mounting panel}}

Underneath the top plate is a standard Sanwa hole pattern, both the central four-hole mounts, and the twin 65mm mounts.  Open it up even further to find that the Hayabusa's oversized base is simply a shell for the microswitches, with soldered-on wires leading to the quick-connect PCB.

{{ :arcade:hori_hayabusa_joystick_mech-2.jpg?400 |Inside the Hori Hayabusa Joystick Mech}}

The pinout for the connector is the same as the Sanwa JLF stick.

==== Measurements ====

{{ :arcade:hayabusa-mech-schematic.png?400 |Hori Hayabusa dimensions diagram}}

{{ :arcade:horihayabusadustwasher.png?400 |Hori Hayabusa dust washer diagram}}

{{ :arcade:horihayabusashaftcover.png?400 |Hori Hayabusa shaft cover diagram}}