This shows you the differences between two versions of the page.

Link to this comparison view

av:cbs_coleco [2019/08/27 20:45] (current)
Line 1: Line 1:
 +====== CBS Colecovision Audio/Video Modification ======
 +{{av:​colecoguts.jpg}} \\ 
 +This information is relevant to the CBS Colecovision (PAL).
 +===== Composite Video =====
 +{{av:​colecoav_2.png}} \\ This is a circuit diagram of the latter part of the Coleco'​s video circuit. Components in red are additional parts required to drive a standard TV/Monitor. The Video wire (blue) must be disconnected (thus disabling the RF out) in order for the transistor amplifier to fuction. I reccomend lifting the leg of Q24 off the board and connecting the 3k3 resistor between the lifted leg and the nearest +5v point as this part if the circuit is susceptible stray capacitance. R140 should be reduced to about 3300 ohms. This actually forms a low pass filter with Q24 (miller effect). You may want to adjust this value to your tase (don't use a pot!). Higher value = softer edges and less dot crawl (chroma interference),​ lower value = sharper edges. The resaulting video signal is of very good quality with only minimal dot crawl.
 +{{av:​colecoav_audio.png}} \\ I didn't bother to trace out the audio circuit. Just intercept the wire going to the modulator board. Use a resistor divider to attenuate the signal.
 av/cbs_coleco.txt ยท Last modified: 2019/08/27 20:45 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki