Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
av:japanese_rgb-15 [2016/05/30 15:33]
lawrence Added intro about the Ys line.
av:japanese_rgb-15 [2018/07/22 14:26] (current)
leonk [CAVEATS]
Line 59: Line 59:
   * Not all systems put out power on pin 7.  Normally +5v, some devices (like the X-RGB2) leave this pin disconnected. ​ You can add power to your cables, for monitors that require it, following [[adding_5v_to_scart_lead|these directions]].   * Not all systems put out power on pin 7.  Normally +5v, some devices (like the X-RGB2) leave this pin disconnected. ​ You can add power to your cables, for monitors that require it, following [[adding_5v_to_scart_lead|these directions]].
   * Remember that the pin numbers are almost always found on the connector itself.   * Remember that the pin numbers are almost always found on the connector itself.
 +  * CRITICAL: H and V sync are TTL level (5Vpp) If you make a SCART cable and tie pins together, you must use a resistor (470ohm - NOT CONFIRMED) to lower voltages to safe levels for 75ohm / 0.3Vpp CSYNC or else you’ll damage the X68K or your display device (eg XRGB mini)
  
 ---- ----
 **Credit:** **Credit:**
   * Some of this info came from [[http://​hp.vector.co.jp/​authors/​VA018718/​towns/​connect/​pinasgn.htm|this Japanese page]].   * Some of this info came from [[http://​hp.vector.co.jp/​authors/​VA018718/​towns/​connect/​pinasgn.htm|this Japanese page]].
 
 av/japanese_rgb-15.txt · Last modified: 2018/07/22 14:26 by leonk
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki