av:playstation_1_sync
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Previous revisionLast revision | |||
— | av:playstation_1_sync [2010/10/26 11:25] – RARusk | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== PlayStation 1 Sync ====== | ||
+ | |||
+ | The purpose of this page is to show where to find the sync signals from PlayStation 1 motherboards so one does not have to use a sync chip. | ||
+ | |||
+ | Unlike the very complicated PlayStation 2, the PlayStation 1 units are very easy to hack. Still, care must be taken whenever one opens up a game console unit. | ||
+ | |||
+ | The following pictures are from a SCPH-7501 unit (Version unknown) motherboard and a SCPH-101 (Version unknown) motherboard. The Composite Sync circuit comes from Viletim!. | ||
+ | |||
+ | Being that this is a Wiki page you are more than welcome to add any information that will improve the quality of information provided here. | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | {{ av:ps1.jpg }} | ||
+ | |||
+ | |||
+ | ===== Standard PlayStation 1 Unit ===== | ||
+ | |||
+ | In the picture below you will see the main chip, the CXD8561, and the video chip, the A2106. You will also see a red rectangle. The sync signals are within this outline. | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | The picture below shows exactly where the Horizontal, Vertical, and Composite Sync signals can be found at the top of the motherboard (within the red rectangle). | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | However, there is also another, and better, place to acquire the signals and that is underneath the motherboard as shown in the picture below. | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | On the Playstation SCPH-5001 you can get the composite sync signal from the Sony CXA1645M encoder (pin 20), which is on the bottom side of the mainboard PCB. | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | ===== Newer PSOne Unit ===== | ||
+ | |||
+ | The smaller PSOne unit uses the exact same chips as in the older model and in the same orientation. So the sync can be easily found and used. | ||
+ | |||
+ | In the picture below you will find where to tap the Horizontal and Vertical Syncs. You will note that there is no Composite Sync to be easily tapped into this time. | ||
+ | |||
+ | {{ av: | ||
+ | |||
+ | You can make your own Composite Sync signal with two very simple components. First, run the Horizontal Sync through a 1N4148 diode (very common - can be found at Radio Shack). Second, run the Vertical Sync through a 820 Ohm resistor. Once the two signals have been conditioned this way then you can simply splice them together. | ||
+ | |||
+ | ---- | ||
+ | |||
+ | Author and pictures: [[http:// | ||
av/playstation_1_sync.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1