av:playstation_2_rgb_sync
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
av:playstation_2_rgb_sync [2006/01/24 16:27] – 66.90.200.118 | av:playstation_2_rgb_sync [2006/02/03 16:25] – 66.90.202.106 | ||
---|---|---|---|
Line 50: | Line 50: | ||
In addition, the sync signals may need to be buffered (using a 74hc244 chip) depending on the monitor being used. | In addition, the sync signals may need to be buffered (using a 74hc244 chip) depending on the monitor being used. | ||
+ | |||
===== The Sync Mixing Chip ===== | ===== The Sync Mixing Chip ===== | ||
Line 57: | Line 58: | ||
If you follow either of the two sync signals you will eventually come to this small chip. This is where the two sync signals become Composite Sync. If you need Composite Sync it is not recommended you get it from here because of the MacroVision copy protection signal which also gets mixed in when needed. | If you follow either of the two sync signals you will eventually come to this small chip. This is where the two sync signals become Composite Sync. If you need Composite Sync it is not recommended you get it from here because of the MacroVision copy protection signal which also gets mixed in when needed. | ||
- | It may actually be possible to find which of these remaining traces to this chip is the MacroVision signals then cut the traces to permanently | + | It may actually be possible to find which of these remaining traces to this chip is the MacroVision signals then cut the traces to permanently |
You can make your own Composite Sync signal with two very simple components. First, run the Horizontal Sync through a 1N4148 diode (very common - can be found at Radio Shack). Second, run the Vertical Sync through a 820 Ohm resistor. Once the two signals have been conditioned this way then you can simply splice them together. | You can make your own Composite Sync signal with two very simple components. First, run the Horizontal Sync through a 1N4148 diode (very common - can be found at Radio Shack). Second, run the Vertical Sync through a 820 Ohm resistor. Once the two signals have been conditioned this way then you can simply splice them together. | ||
Line 64: | Line 65: | ||
{{ av: | {{ av: | ||
+ | |||
===== Theory of RGB Operation (SCPH-50000 unit) ===== | ===== Theory of RGB Operation (SCPH-50000 unit) ===== | ||
Line 69: | Line 71: | ||
In this model Sony did some major revisioning. They removed the Firewire port, quieted down the fan and DVD drive, and added Progressive Scan DVD playback. | In this model Sony did some major revisioning. They removed the Firewire port, quieted down the fan and DVD drive, and added Progressive Scan DVD playback. | ||
- | Unfortunately, | + | Unfortunately, |
Worse, I could not even find stable sync from this style of motherboard. | Worse, I could not even find stable sync from this style of motherboard. |
av/playstation_2_rgb_sync.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1