av:snes2rgb
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
av:snes2rgb [2014/02/01 10:08] – ApolloBoy | av:snes2rgb [2014/02/01 10:09] – ApolloBoy | ||
---|---|---|---|
Line 22: | Line 22: | ||
- | In the third picture above is where the four wires are attached to the bottom of the SNES2 AV port. In this picture the white wire (for composite sync) obscures where the red wire is attached for pin 1 but all four wires are attached. A clear insulating compound | + | In the third picture above is where the four wires are attached to the bottom of the SNES2 AV port. In this picture the white wire (for composite sync) obscures where the red wire is attached for pin 1 but all four wires are attached. A clear insulating compound was used to help protect the connections and exposed wire. Make sure to add the resistors to these pins if they are not present in your RGB cable. |
av/snes2rgb.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1