controls:snes_con_region_fix
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
controls:snes_con_region_fix [2008/07/23 17:46] – 122.49.159.159 | controls:snes_con_region_fix [2019/08/27 20:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 25: | Line 25: | ||
For the other revision, you will need the same two resistors, but because the PCB lacks places for the ' | For the other revision, you will need the same two resistors, but because the PCB lacks places for the ' | ||
- | [[http://phreak97.experienced.tk/phreak97/GameSX/ | + | [[http://i189.photobucket.com/ |
If you find it too difficult to solder the resistors directly to these points, you may run wires from them and put the resistors anywhere you like inside the controller, so long as they are fixed down with something like electrical tape or hot glue, and will not move about. | If you find it too difficult to solder the resistors directly to these points, you may run wires from them and put the resistors anywhere you like inside the controller, so long as they are fixed down with something like electrical tape or hot glue, and will not move about. | ||
Line 42: | Line 42: | ||
=== Pad Externals === | === Pad Externals === | ||
- | [[http://phreak97.experienced.tk/phreak97/GameSX/ | + | [[http://i189.photobucket.com/ |
* Click for larger image | * Click for larger image | ||
=== Pad Internals === | === Pad Internals === | ||
- | [[http://phreak97.experienced.tk/phreak97/GameSX/ | + | [[http://i189.photobucket.com/ |
* Click for larger image | * Click for larger image | ||
== US Pad == | == US Pad == | ||
- | [[http://phreak97.experienced.tk/phreak97/GameSX/ | + | [[http://i189.photobucket.com/ |
== Japanese Pad == | == Japanese Pad == | ||
- | [[http://phreak97.experienced.tk/phreak97/GameSX/ | + | [[http://i189.photobucket.com/ |
* Note the unused solder pads for resistors R1 and R2 (Also highlighted in white, and labled ' | * Note the unused solder pads for resistors R1 and R2 (Also highlighted in white, and labled ' | ||
== PAL Pad == | == PAL Pad == | ||
- | [[http://phreak97.experienced.tk/phreak97/GameSX/ | + | [[http://i189.photobucket.com/ |
* Note the resistors at R1 and R2 (only-P positions). | * Note the resistors at R1 and R2 (only-P positions). | ||
* R1 is a 1.2k resistor (labled ' | * R1 is a 1.2k resistor (labled ' |
controls/snes_con_region_fix.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1