Differences

This shows you the differences between two versions of the page.

--- imports:sega_saturn [2006/04/22 09:27] – At europe saturns pin7 is closed (not pin 6!) 88.73.208.247
+++ imports:sega_saturn [2019/08/27 20:45] (current) – external edit 127.0.0.1
@@ Line 15: / Line 15: @@
 <box warning round |Common Points>It's not strictly necessary to know where the common points are if you're making a permanent change.  If you're installing a switch, you **must** connect the common point to the center leg of the switch, or you will connect +5V and GND, and then sparks fly (and Saturns die).</box>
 ==== The Country Codes ====
 This table lists the jumpers that should be CLOSED to set a certain region.
-^Region^Jumpers (Closed Jumpers)^^^^
-(Is this table correct? According to the voltage table below, Either "Do Not Use" configuration should result in all ground or all +5v. However, in the "Locating the Jumpers" images, they clearly show that the pin configuration results in at least one of the pins jumping a +5v.)
+Note: I (phreak97) Just modded an early Japanese saturn which had JP6 and JP7 reversed. It took me ages to figure out that it was set to south america instead of USA.
+You can tell if yours is reversed by confirming the jumper positions before you start. This console according to the jumper labels appeared to be set to "Do Not Use" but was actually set to Japan as it should have been.
+^Region^Jumpers (Closed Jumpers)^^^^
 ^.^JP6/JP7^JP8/JP9^JP10/JP11^JP12/JP13^
 ^  Do Not Use |     JP6  |  JP9  |  JP11  |  JP13  |
-^  Japan |          JP7  |  JP9  |  JP11  |  JP13  |
+^  Japan |          JP6  |  JP9  |  JP11  |  JP13  |
 ^  Asia NTSC |      JP6  |  J08  |  JP11  |  JP13  |
 ^  Sega Reserved |  JP7  |  J08  |  JP11  |  JP13  |
-^  North America |  JP6  |  JP9  |  JP10  |  JP13  |
+^  North America |  JP7  |  JP9  |  JP10  |  JP13  |
 ^  Mid + S America NTSC	|  JP7  |  JP9  |  JP10  |  JP13  |
 ^  Korea |          JP6  |  J08  |  JP10  |  JP13  |
@@ Line 35: / Line 36: @@
 ^  Asia PAL |       JP6  |  J08  |  JP11  |  JP12  |
 ^  Sega Reserved |  JP7  |  J08  |  JP11  |  JP12  |
-^  Europe PAL |     JP7  |  JP9  |  JP10  |  JP12  |
+^  Europe Etc |     JP6  |  JP9  |  JP10  |  JP12  |
 ^  Mid + S America PAL |  JP7  |  JP9  |  JP10  |  JP12  |
 ^  Sega Reserved |  JP6  |  J08  |  JP10  |  JP12  |
@@ Line 59: / Line 60: @@
 ^  Sega Reserved |  GND  |  +5v  |  +5v  |  +5v  |
 ^  Do Not Use |  +5v  |  +5v  |  +5v  |  +5v  |
 ==== Locating The Jumpers ====