Differences

This shows you the differences between two versions of the page.

--- ps2psxlcd:sony_psx_screen_on_ps2_info [2010/01/26 10:19] – tertiumsquid
+++ ps2psxlcd:sony_psx_screen_on_ps2_info [2022/04/08 14:11] (current) – tertiumsquid
@@ Line 1: / Line 1: @@
-Will be updating/completing shortly.
 A common problem with creating portable PSTwo systems is that the screen turns green after 20 or 30 minutes.  There is now a permanent fix.
@@ Line 25: / Line 23: @@
 Now for pictures:
-{{:ps2psxlcd:crw_1370.jpg|}}
 These are the 3 caps in question. Basically, I've removed them and resoldered them upright, so as to only connect on one end. I then soldered the 3 wires to the PCB input connector. Note that I've lifted the lower side of the cap up, so that it's standing only on the upper connection of the footprint.
-{{:ps2psxlcd:crw_1371.jpg|}}
+{{:ps2psxlcd:crw_1370.jpg|}}
 Here's the other end of those wires. I used 30ga insulated magnet wire for this, but you can use whatever you want. On the input connector, pins 4, 5, and 6 (counted from bottom up) correspond to red, green, and blue.
+{{:ps2psxlcd:crw_1371.jpg|}}
+Here's Okami after about 90 minutes:
+{{:ps2psxlcd:crw_1398.jpg|}}
+Any question or comments, please post in my original thread [[http://forums.benheck.com/viewtopic.php?f=7&t=32915|here]].  Feel free to use this info anywhere, so long as credit is given to Simon Allan, and so long as the info is distributed freely.