x68000:040excel_necessary_modifications
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
x68000:040excel_necessary_modifications [2015/06/14 15:56] – hyperneogeo | x68000:040excel_necessary_modifications [2015/07/12 08:21] – hyperneogeo | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== 040EXCEL Necessary Modifications ===== | ===== 040EXCEL Necessary Modifications ===== | ||
- | If you're lucky enough to find yourself in possession of an 040EXCEL accelerator board, there are some things you'll need. First, grab [[gamesx>x68000/ | + | If you're lucky enough to find yourself in possession of an 040EXCEL accelerator board, there are some things you'll need. First, grab [[http:// |
The photos are terrible because 1998, so if you're doing any of these mods, please snap some new ones. | The photos are terrible because 1998, so if you're doing any of these mods, please snap some new ones. | ||
Line 59: | Line 59: | ||
{{ : | {{ : | ||
- | Next there are 2 AS245s, connect the 19th pin to the reconfiguring cable, and 10th pin to ground. And then make 2 jumper sockets. And configure the jumpers as 2-18, 3-17.....9-11... etc. | + | Next there are 2 AS245s, connect the 19th pins to the reconfiguring cable, and 10th pin to ground. And then make 2 jumper sockets. And configure the jumpers as 2-18, 3-17.....9-11... etc. |
次にAS245を二つの、19ピンに改造用ケーブルの線をつなぐ。もち、10ピンはGND。 | 次にAS245を二つの、19ピンに改造用ケーブルの線をつなぐ。もち、10ピンはGND。 | ||
Line 66: | Line 66: | ||
{{ : | {{ : | ||
- | Put IC 4, 5 in the jumper socket, then IC11, 12...and that should do it for the AS245s. Finally take the reconfiguring cable and connect it to the EXCEL, then you are done. | + | Put IC 4, 5 in the jumper socket, then the AS245s into IC11, 12 ...and that should do it for the AS245s. Finally take the reconfiguring cable and connect it to the EXCEL, then you are done. |
IC4,5にジャンパソケット、IC11,12に改造済みAS245、改造用ケーブルをエクセルにつないで完成。 | IC4,5にジャンパソケット、IC11,12に改造済みAS245、改造用ケーブルをエクセルにつないで完成。 |
x68000/040excel_necessary_modifications.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1