Differences
This shows you the differences between two versions of the page.
| Next revisionBoth sides next revision |
x68000:advanced_floppy_driver_repair [2010/03/29 05:29] – created eidis | x68000:advanced_floppy_driver_repair [2010/03/29 06:41] – eidis |
---|
{{:x68000:floppy_02.jpg|}} | {{:x68000:floppy_02.jpg|}} |
| |
Remove the signal cables by pulling them in straight direction away from the socket. Use tweezers for gently disconnecting the big brown signal cables and use extreme caution when disconnection the signal cable which goes to the step motor. Grab its wires tight at the base of the plastic so that they are not loose and gently jiggle the plug out of the socket. Unscrew the eight circled screws. Please note that by unscrewing the four screws from the rotating disk assembly allows better access to capacitors and makes replacing them a bit easier. | Remove the signal cables by pulling them in straight direction away from the socket. Use tweezers to gently disconnect the big brown signal cables and use extreme caution when disconnection the signal cable which goes to the step motor. Grab its wires tight at the base of the plastic so that they are not loose and gently jiggle the plug out of the socket. Unscrew the eight circled screws. Please note that by unscrewing the four screws from the rotating disk assembly allows better access to capacitors and makes replacing them a bit easier. |
| |
{{:x68000:floppy_03.jpg|}} | {{:x68000:floppy_03.jpg|}} |
Right: 1uf 50v BP | Right: 1uf 50v BP |
| |
Use tweezers for getting them in position. This task is rather tricky. | Use tweezers to get them in position. This task is rather tricky. |
| |
{{:x68000:floppy_08.jpg|}} | {{:x68000:floppy_08.jpg|}} |