Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
x68000:atx_power-on_signal_inverter [2014/08/15 18:12]
eidis
x68000:atx_power-on_signal_inverter [2019/08/27 20:45] (current)
Line 3: Line 3:
 The following info was kindly contributed by our forum member **Arcade** The following info was kindly contributed by our forum member **Arcade**
  
-X68000 has inverted power-on signal and [[http://​nfggames.com/​nfg/​x68repair/​|Power Supply Replacement]] suggests using an invertor IC (a [[http://​nfggames.com/​x68000/​Documentation/​Datasheets/​74HC_HCT04.pdf|74HC04]]) and a resistor (4.7k Ohm). For a smaller solution and less soldering you can use [[http://​nfggames.com/​x68000/​Documentation/​Datasheets/​2N7000.pdf|2N7000]] N-channel MOSFET instead. Connect '​source'​ to ground, '​drain'​ to the ATX '​PS_ON#'​ pin, and then the yellow wire from the X68K to '​gate'​.+X68000 has inverted power-on signal and [[http://​nfggames.com/​nfg/​x68repair/​|Power Supply Replacement]] suggests using an invertor IC (a [[http://​nfggames.com/​x68000/​Documentation/​Datasheets/​74HC_HCT04.pdf|74HC04]]) and a resistor (4.7k Ohm) with the replaced power supply. For a smaller solution and less soldering you can use [[http://​nfggames.com/​x68000/​Documentation/​Datasheets/​2N7000.pdf|2N7000]] N-channel MOSFET instead. Connect '​source'​ to ground, '​drain'​ to the ATX '​PS_ON#'​ pin, and then the yellow wire from the X68K to '​gate'​.
 
 x68000/atx_power-on_signal_inverter.txt ยท Last modified: 2019/08/27 20:45 (external edit)
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki