x68000:h.a.r.p_for_mc68000_-_cpu_accelerator_board
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
x68000:h.a.r.p_for_mc68000_-_cpu_accelerator_board [2012/01/26 02:42] – eidis | x68000:h.a.r.p_for_mc68000_-_cpu_accelerator_board [2019/08/27 20:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 9: | Line 9: | ||
{{: | {{: | ||
- | There is a red dipswitch in the center of the photo labeled SW1. if you normally use, at any one time under the 2 (OFF) If it is OK to. | + | There is a red dipswitch in the center of the photo labeled SW1. Both switches must be set to OFF for normal operation. Switch 1 must be set to ON when this device is used along with a Jast made memory expansion. |
- | SW1 when used with Memory Co., Ltd. - It is said that just made to ON 1. | + | |
- | ☆ ☆ ☆ Oh! ☆ ☆ ☆ X Information | + | ☆ ☆ ☆ Oh!X Information |
- | H.A.R.P will be doubled to 20MHz internal clock of the CPU, 2x accelerator. But the body remains at 10MHz from the street now, I needed it to arbitration. | + | |
- | That is, when calculated in the CPU is even moving into full-20MHZ, when accessing the external bus is considerably 落Tosane do not have to 10MHz. | + | |
- | Therefore, the actual rate of say what happens, "We have only about 10% faster!" | + | |
+ | H.A.R.P will accelerate the CPU and double its internal clock from 10MHz to 20MHz. However the factory default system bus speed will remain at 10MHz because it is needed for arbitration. That is, it will work in 20MHz when CPU calculates and in 10MHz when accessing external bus. Therefore, the actual speed increase is only about 10%. |
x68000/h.a.r.p_for_mc68000_-_cpu_accelerator_board.1327509753.txt.gz · Last modified: 2019/08/27 20:44 (external edit)