Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
x68000:how_to_open_x68000_compact [2014/08/13 05:52] – eidis | x68000:how_to_open_x68000_compact [2014/08/13 05:59] – eidis |
---|
|{{:x68000:open_compact_22.jpg?300|}}| Carefully and slowly remove the base. It should be possible to remove it without bending the shielding and without using force. | | |{{:x68000:open_compact_22.jpg?300|}}| Carefully and slowly remove the base. It should be possible to remove it without bending the shielding and without using force. | |
|{{:x68000:open_compact_23.jpg?300|}}| Unplug the speaker cable. | | |{{:x68000:open_compact_23.jpg?300|}}| Unplug the speaker cable. | |
|{{:x68000:open_compact_24.jpg?300|}}| I will remove slowly or something pliers. You should remember where the enclosure cable speaker whether through before removing. | | |{{:x68000:open_compact_24.jpg?300|}}| Unplug the circled connector. | |
|{{:x68000:open_compact_25.jpg?300|}}| And lower connector board (mouse keyboard joystick) (Easiest) to remove the nails of plastic (white) two positions I Remove the flat cable. | | |{{:x68000:open_compact_25.jpg?300|}}| | |
|{{:x68000:open_compact_26.jpg?300|}}| | | |{{:x68000:open_compact_26.jpg?300|}}| Remove the lower connector board (mouse keyboard joystick). Unhook the white plastic tabs and unplug the flat cable. | |
|{{:x68000:open_compact_27.jpg?300|}}| You will work to remove the body of the main board from here Make sure the position (plastic? Vinyl? Still in place) of the claws turned over to the back side of the substrate. I will continue to remove the order from the white part of the nail. | | |{{:x68000:open_compact_27.jpg?300|}}| Unhook the white plastic tabs and remove the motherboard. | |
|{{:x68000:open_compact_28.jpg?300|}}| I will continue to remove the claws of the black part later. You remember well the wiring of the flat cable that is connected to the bottom connector board 1. Once ready to board floats. → I want to be easy to leave the flat cable 2.FDD, rear connector board (SCSI), which goes through the position has changed. If pulling as it is, you can remove the board. | | |{{:x68000:open_compact_28.jpg?300|}}| | |