Differences

This shows you the differences between two versions of the page.

--- x68000:how_to_open_x68000_compact [2014/08/13 05:55] – eidis
+++ x68000:how_to_open_x68000_compact [2014/08/13 18:11] – eidis
@@ Line 5: / Line 5: @@
 |{{:x68000:open_compact_01.jpg?300|}}|  Unscrew the screw at the bottom.  |
 |{{:x68000:open_compact_02.jpg?300|}}|  Slide and remove the bottom part.  |
-|{{:x68000:open_compact_03.jpg?300|}}|  Remove the expansion board cover. Remove the panel on the left when viewed from the front.  |
+|{{:x68000:open_compact_03.jpg?300|}}|  Remove the expansion board cover. Open the left panel, when viewed from the front.  |
 |{{:x68000:open_compact_04.jpg?300|}}|  Remove the panel on the right side. Remove the shield on the left. Remove the back panel. It removes from bottom to top.  |
 |{{:x68000:open_compact_05.jpg?300|}}|  |
@@ Line 27: / Line 27: @@
 |{{:x68000:open_compact_23.jpg?300|}}|  Unplug the speaker cable.  |
 |{{:x68000:open_compact_24.jpg?300|}}|  Unplug the circled connector.  |
-|{{:x68000:open_compact_25.jpg?300|}}|  Remove the lower connector board (mouse keyboard joystick). Unhook the white plastic tabs and unplug the flat cable.  |
+|{{:x68000:open_compact_25.jpg?300|}}| |
-|{{:x68000:open_compact_26.jpg?300|}}| |
+|{{:x68000:open_compact_26.jpg?300|}}|  Remove the lower connector board (mouse keyboard joystick). Unhook the white plastic tabs and unplug the flat cable.  |
-|{{:x68000:open_compact_27.jpg?300|}}|  You will work to remove the body of the main board from here Make sure the position (plastic? Vinyl? Still in place) of the claws turned over to the back side of the substrate. I will continue to remove the order from the white part of the nail.  |
+|{{:x68000:open_compact_27.jpg?300|}}|  Unhook the white plastic tabs and remove the motherboard.  |
-|{{:x68000:open_compact_28.jpg?300|}}|  I will continue to remove the claws of the black part later. You remember well the wiring of the flat cable that is connected to the bottom connector board 1. Once ready to board floats. → I want to be easy to leave the flat cable 2.FDD, rear connector board (SCSI), which goes through the position has changed. If pulling as it is, you can remove the board.  |
+|{{:x68000:open_compact_28.jpg?300|}}| |