Differences

This shows you the differences between two versions of the page.

--- x68000:soft_power_switch_troubleshooting_and_repair [2012/11/21 00:17] – eidis
+++ x68000:soft_power_switch_troubleshooting_and_repair [2019/08/27 20:45] (current) – external edit 127.0.0.1
@@ Line 20: / Line 20: @@
 The problem might be due to a signal that is always stuck Low.
-If you look at the Buffered IO part in the schematics, 3 of these signals are connected to the MFP GPIP port. They can be queried via software and are connected like this :
+If you look at the Buffered IO part in the schematics, 3 of these signals are connected to the MFP GPIP port.
+**They can be queried via software and are connected like this :**
 |/RTC_ALARM  |GPIP0  |
@@ Line 28: / Line 30: @@
 **A program for testing these signals can be found here :**
-[[http://nfggames.com/X68000/Misc/SoftPower%20Test%20Program/x68k_pwrtest.zip|X68k Power Test]]
+[[http://nfggames.com/X68000/Misc/Diagnostics/SoftPower%20Test%20Program/x68k_pwrtest.zip|X68k Power Test]]
 **Execute it more than one time. You should get :**
@@ Line 49: / Line 51: @@
   *Bad IC28 (74LS08) (stuck output).
   *Bad Q9 transistor (shorted).
-  *Bad C64 (generating noise).
+  *Bad C64 capacitor (generating noise).
   *IC29 (74LS244) might have bad output on pin 5.
   *The power signal from the main board, which I miss infos actually. A fix to this could be soldering a 10K ohm resistor between IC28 pin 10 and 14.