xbox_pcdvd
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
xbox_pcdvd [2009/06/06 22:36] – created 115.64.16.210 | xbox_pcdvd [2009/06/07 05:49] – Adding Samsung drives. 66.229.56.204 | ||
---|---|---|---|
Line 9: | Line 9: | ||
In addition, the Xbox is not compatible with all DVD players, even with the electronic interfaces described here. The information right now is that the Xbox expects the DVD to always be spinning, and never //spin down//. Data errors occur if the drive goes into a spin down mode. | In addition, the Xbox is not compatible with all DVD players, even with the electronic interfaces described here. The information right now is that the Xbox expects the DVD to always be spinning, and never //spin down//. Data errors occur if the drive goes into a spin down mode. | ||
- | The drive that is supplied with the Xbox is made by either Philips or Thompson | + | The drive that is supplied with the Xbox is made by either |
===== Connector Signals ===== | ===== Connector Signals ===== | ||
Line 39: | Line 39: | ||
In addition, if it is desired to have the eject button on the PC-DVD inform the Xbox that the CD has been ejected, then a connection must be made from the NEJECT wire to the back of the Eject button on the front panel. The correct trace is the top one through an opening in the metal shielding. From the back, you can see four PCB pads, and the top two are connected together with a PCB trace. This is the location to connect the NEJECT signal, through a 3.3K resistor for a wired OR connection. | In addition, if it is desired to have the eject button on the PC-DVD inform the Xbox that the CD has been ejected, then a connection must be made from the NEJECT wire to the back of the Eject button on the front panel. The correct trace is the top one through an opening in the metal shielding. From the back, you can see four PCB pads, and the top two are connected together with a PCB trace. This is the location to connect the NEJECT signal, through a 3.3K resistor for a wired OR connection. | ||
- | A schematic of the connector pinout and a sample interface circuit for the SD-M1302 is provided in this document: | + | A schematic of the connector pinout and a sample interface circuit for the SD-M1302 is provided in this document: |
===== Compatible DVD Drives ===== | ===== Compatible DVD Drives ===== | ||
Line 57: | Line 57: | ||
Credits go to PSXBase. Although I did not use any of their information directly, the original article was an inspiration and very helpful. | Credits go to PSXBase. Although I did not use any of their information directly, the original article was an inspiration and very helpful. | ||
- | [NOTE: This is a mirror of a page once located at http:// | + | [NOTE: This is a mirror of a page once located at http:// |
xbox_pcdvd.txt · Last modified: 2019/08/27 20:45 by 127.0.0.1