av:adding_5v_to_scart_lead
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
av:adding_5v_to_scart_lead [2006/10/30 14:07] – created nfg | av:adding_5v_to_scart_lead [2020/07/28 08:48] (current) – Added connector detail NFG | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Adding +5v to SCART cable ===== | ===== Adding +5v to SCART cable ===== | ||
- | It's an unfortunate truth that not all hardware provides power on the video output. | + | It's an unfortunate truth that not all hardware provides power on the video output. |
This mod is a solution to the problem, and while the specifics may apply only to the X-RGB2 the theory is valid for any device that doesn' | This mod is a solution to the problem, and while the specifics may apply only to the X-RGB2 the theory is valid for any device that doesn' | ||
==== The Solution ==== | ==== The Solution ==== | ||
- | I used a short length of cable with two DB15 connectors on it, one male and the other female, to create the shortest extension cable I've ever seen. On the output end I added a short little tail with a clip-on connector, connected inside to pins 7 and 8 (power and ground, respectively). | + | I used a short length of cable with two [[japanese_rgb-15|DB15 connectors]] on it, one male and the other female, to create the shortest extension cable I've ever seen. On the output end I added a short little tail with a clip-on connector, connected inside to pins 7 and 8 (power and ground, respectively). |
+ | |||
+ | {{av: | ||
+ | |||
+ | You'll need a power supply of course. | ||
+ | |||
+ | {{av: | ||
- | You'll need a power supply of course. | ||
==== Caveats ==== | ==== Caveats ==== | ||
Line 15: | Line 20: | ||
* Use a reliable connector for the power, and use some wire that's thick enough to not break off or wear out during normal use. | * Use a reliable connector for the power, and use some wire that's thick enough to not break off or wear out during normal use. | ||
- | === Apologies | + | === Connector |
- | I don't know what the connector is called that I used for power. I bought a handful of them in Japan, they weren' | + | The 2-pin connector |
+ | |||
+ | == Alternative for Scart == | ||
+ | * A quick fix can be implemented by using a 9V battery (positive lead on Pin 8, negative lead on any of the grounds) and a 150 Ohms resistor between Pin 8 and Pin 16. | ||
+ | * Either three or four AA batteries can be used as well.(definitely use four if they' |
av/adding_5v_to_scart_lead.txt · Last modified: 2020/07/28 08:48 by NFG