x68000:cz600c_floppy_caps
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
x68000:cz600c_floppy_caps [2019/02/07 08:18] – leonk | x68000:cz600c_floppy_caps [2019/08/27 20:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 27: | Line 27: | ||
Follow the following set of pictures as you take the FDD apart. | Follow the following set of pictures as you take the FDD apart. | ||
- | Start by removing | + | NOTE: You can click the pictures below to see full size close-ups. |
- | {{: | + | |
- | On the other side of the drive, remove | + | - Start by removing |
- | {{: | + | |
- | After the shield is out of the way, you will need to remove 3 ribbon cables. Afterwards, remove the 2 FDD head cable connectors. | + | {{:x68000:og_fdd_repair1.jpg?300|}} |
- | {{:x68000:og_fdd_repair3.jpg?nolink&300|}} | + | |
- | At this point, | + | - On the other side of the drive, remove |
- | {{:x68000:og_fdd_repair4.jpg? | + | |
- | Pull the ribbon cable out from the other side, and start rotating carefully the floppy eject mechanism away from the FDD body. Pay close attention on how everything is assembled. | + | {{:x68000:og_fdd_repair2.jpg?300|}} |
- | {{:x68000:og_fdd_repair5.jpg?nolink&300|}} | + | |
- | Finally, you exposed the 3 bolts holding | + | - After the shield is out of the way, you will need to remove |
- | {{: | + | |
+ | {{: | ||
+ | - At this point, the main drive PCB has been removed. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Pull the ribbon cable out from the other side, and start rotating carefully the floppy eject mechanism away from the FDD body. Pay close attention on how everything is assembled. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Finally, you exposed the 3 bolts holding the FDD spin motor PCB. Unscrew them: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== Capacitor Maps ==== | ||
+ | |||
+ | Now that you freed the 2 PCBs with the capacitors on them as shown below. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== Final assembly ==== | ||
+ | |||
+ | Reverse the order shown above to put the FDD back together. It is wise to do other maintenance at this point as well, including: | ||
+ | |||
+ | * remove any dust and dirt from all the parts | ||
+ | * use isopropyl + qtip to clean all the old grease where you see it | ||
+ | * clean the FDD head with clean qtip dipped in isopropyl | ||
+ | * lube the FDD gears using 100% white lithium grease as well as under the FDD head arm (this reduces friction and makes the drive work better) | ||
x68000/cz600c_floppy_caps.1549491491.txt.gz · Last modified: 2019/08/27 20:44 (external edit)